I recently found an old Focus Hard card for the IIgs (and IIe according to the manual).
The hard drive was bad on it, easily replaced and repartitioned using their software. NOTE: It takes many many hours to format a 30G drive.
The card works with GS/OS on my ROM03 machine just fine.
I reformatted it as regular ProDOS 8 so I could use it in a IIe or my ROM00 IIgs.
There are two problems with this:
1) With ProDOS 8 on the hard drive, the machine will not reboot reliably. Sometimes it boots fine, other times it dumps to the monitor.
From a complete power off, it works. However, rebooting the machine almost always results in a dump to the monitor.
00/2000: 00 00 BRK 00
A=FF00 X=0000 Y=0003 S=01FA D=0000 P=32
B=00 K=00 M=0C Q=A8 L=1 m=1 x=1 e=1
*
Maybe it doesn't like too many partitions? It has at least 30.
I will try a smaller drive when I get a CF. I don't think it can see much of this 30G drive anyway.
2) The card isn't recognized at all in my ROM00 GS. It isn't like the partitions aren't seen- the card isn't seen at all. I have checked for "your card" in the control panel, and even tried different slots- it doesn't even flicker the activity light. Nothing- dead!
Is the Focus card not known to work in a ROM00 IIgs? The manual says it will even work in a IIe, although I haven't tried that yet.
Also, does anyone have any ROM01 upgrade chips that they might spare one? Smile
The hard drive was bad on it, easily replaced and repartitioned using their software. NOTE: It takes many many hours to format a 30G drive.
The card works with GS/OS on my ROM03 machine just fine.
I reformatted it as regular ProDOS 8 so I could use it in a IIe or my ROM00 IIgs.
There are two problems with this:
1) With ProDOS 8 on the hard drive, the machine will not reboot reliably. Sometimes it boots fine, other times it dumps to the monitor.
From a complete power off, it works. However, rebooting the machine almost always results in a dump to the monitor.
00/2000: 00 00 BRK 00
A=FF00 X=0000 Y=0003 S=01FA D=0000 P=32
B=00 K=00 M=0C Q=A8 L=1 m=1 x=1 e=1
*
Maybe it doesn't like too many partitions? It has at least 30.
I will try a smaller drive when I get a CF. I don't think it can see much of this 30G drive anyway.
2) The card isn't recognized at all in my ROM00 GS. It isn't like the partitions aren't seen- the card isn't seen at all. I have checked for "your card" in the control panel, and even tried different slots- it doesn't even flicker the activity light. Nothing- dead!
Is the Focus card not known to work in a ROM00 IIgs? The manual says it will even work in a IIe, although I haven't tried that yet.
Also, does anyone have any ROM01 upgrade chips that they might spare one? Smile