Hey Guys,
I have two brand new Centronics printer cables (third party) labeled "for the TRS 80 Model II." One end is the standard male Centronics, the other the typical card edge connector. While an older cable works on my Model 1/4 for printing, the two new cables do not. I would have thought the Centronics standard was, well...standard. Or do I have two bad cables?
Cary
I have two brand new Centronics printer cables (third party) labeled "for the TRS 80 Model II." One end is the standard male Centronics, the other the typical card edge connector. While an older cable works on my Model 1/4 for printing, the two new cables do not. I would have thought the Centronics standard was, well...standard. Or do I have two bad cables?
Cary