I'm sure most of you DEC hackers have replaced a broken DEC handle or put handles on a protoboard, and did what I've done in the past: use 4-40 screws and nuts, or pop rivets. Well, I finally came across the right tool for the job, an Indestro tubular rivet set! I cut the head off of a rivet on an old Sundstrand CNC control board that was getting scrapped anyway and discovered they're 1/8" hollow brass rivets, but that a M3 x 5mm is close enough. You can buy the M3 rivets online for cheap, I paid $6 USD for 200 rivets, shipped. Here's the writeup:
http://www.glitchwrks.com/2017/04/25...ng-dec-handles
My XYlogics Unibus grant card, with a green handle properly riveted on:
![]()
http://www.glitchwrks.com/2017/04/25...ng-dec-handles
My XYlogics Unibus grant card, with a green handle properly riveted on:
