Help Wiring A Turbo Switch/LED and MHz Display

Evening,

So I'm having real trouble re-wiring my turbo SW/LED and MHz Display. I took photos of the setup when I took the case apart, but my phone got stolen so I'm at square one. I'm hoping some one has done this before?

The first picture shows the motherboard pin outs:

17859125_10208778362723094_825187589_o.jpg

The first two pins are marked turbo switch and the second two turbo LED.

17858201_10208778363283108_2046094790_o.jpg

Currently I have a 3 wire plug named turbo SW attached to the two pins marked turbo switch. I've tried it all different ways round but I've read it doesn't matter which way it goes in. This cable is attached to the button on the case with turbo written on it.

Next to it on the two turbo LED pins I have an un-named blue and black cable (let's call it cable x)

17858324_10208778361323059_1265189134_o.jpg

On the circuit board in the case with the 7 seg displays on it I have series of pins:

17902094_10208778361883073_88097202_o.jpg

These are marked from the top down:

- LED -
- LED+
- S-
- S+
- GND
- B+

17858324_10208778361323059_1265189134_o.jpg

I have the Turbo LED on the case (which has a very short lead) wired in to LED +/-. S +/- go to cable x as mentioned above. Finally I have the GND and + 5V wired in to GND and B+.

I've tried this and a million other configurations (hopefully I haven't blown anything up....) but I'm having no luck...

Any assistance would be really appreciated.

Cheers guys.

Attached Images

• 17859125_10208778362723094_825187589_o.jpg (97.2 KB)
• 17858201_10208778363283108_2046094790_o.jpg (96.7 KB)
• 17858324_10208778361323059_1265189134_o.jpg (95.5 KB)
• 17902094_10208778361883073_88097202_o.jpg (99.7 KB)