I am trying to add a LoTech EMS card to my Tandy 1000, I have tried several jumper configurations with varying results. Some disable my VGA card, one configuration disabled the Hard Disk, among other problems.
The Tandy has:
A Full 768 K RAM.
80286 CPU and 80287 Math Co-Processor.
Cirrus Logic 256 K VGA card
LoTech XT IDE Controller with a 1 GB Attached IDE CF Card.
Western Digital WD8003E NIC card
LoTech EMS card (2 MB Variety)
The LTEMM.EXE Driver says that no Memory was detected.
Wolfenstien 3D, which has support for expanded Memory hangs.
If anyone knows any good trouble shooting or diagnostic methods, please speak up.
The Tandy has:
A Full 768 K RAM.
80286 CPU and 80287 Math Co-Processor.
Cirrus Logic 256 K VGA card
LoTech XT IDE Controller with a 1 GB Attached IDE CF Card.
Western Digital WD8003E NIC card
LoTech EMS card (2 MB Variety)
The LTEMM.EXE Driver says that no Memory was detected.
Wolfenstien 3D, which has support for expanded Memory hangs.
If anyone knows any good trouble shooting or diagnostic methods, please speak up.